The modeling line of horizontal parting detachable box is easy to misplace
Because of the design of the horizontal parting line, the casting is
easy to produce wrong box. For the new equipment, without considering
the mold factor, the causes of wrong box are as follows:
① The pin and sleeve of positioning sand box or formwork are worn fast,
which affects the positioning accuracy. It should be checked regularly
and replaced in time.
②推型速度过快，导致上下型移位。上下型合箱粪池模具 路缘石模具 唐山通风管道 塑钢电缆挂钩 钢纤维 钢制拍门 植绒机 铜雕佛像
② The pushing speed is too fast, resulting in the up and down type
displacement. After the upper and lower closure, the inner closure
station of the molding machine is pushed to the auxiliary line, usually
to ensure the efficiency and high speed of the production line.
Especially when the molding line runs for a long time and the wheels of
the transport trolley on the auxiliary line are worn, which causes the
upper plane of the trolley to be lower than the closing position, the
phenomenon of wrong box will be more serious.
③ The positioning of the auxiliary line transport car is too simple, and
some types of modeling line transport cars even have no design
positioning. The positioning accuracy is not high, so it is difficult to
ensure the coincidence between the center of the casing and the center
of the sand mold, which will directly cause the casing to touch the
upper mold and form the upper mold displacement, resulting in the wrong